Water Filtration


Water Filtration Systems

In order for water to be used in most cases after pumping it will need to be filtered to some degree. The type of filtration required depends on the proposed use of the water. If the water is to be just for irrigation then often no filtration is necessary or a simple sediment filter to catch any sand particles.
If however you intend to drink the water then some or all of the items listed below may apply to you.
The type of filtration you may need will depend on the results of your water analysis.
If you are to drink or consume the water it MUST be filtered to keep in line with the drinking water standards regulations which states the minimum if the water is pure (proven by water test results) there must be an Ultra violet light and sediment filter fitted.
As a guide to filtration please read the following: (Click links for more information)

Stage one – Remove solid particulate.

The process of pumping water through what are known as sediment filters. These types of filters remove solid particulate from the water. Solid contaminants such as grit, organic matter, sand etc will always be encountered and can be seen with the naked eye. Contaminants in dilution can also be removed with this method and usually cannot be seen with the naked eye.

Stage two – Remove metals especially iron. (dependant on results)

The presence of high levels of metals in your water can cause numerous problems both in terms of health & equipment. Iron for example can in high quantities, give the water an unpleasant metal taste & colour it dark brown or orange. It will also stain anything it comes into contact with and is not good for humans.

Stage three – Soften water or Harden The Water (if required)

If required, is to add a water softener. If the water is to be used in heating systems for example a water heater, tap or shower head, a water softener is advisable to prevent scale build up. This is particularly necessary in hard water areas.
In some cases the water can be lower then 7 which is acidic. A ph level of 6 is more acidic then a level of 7 by 10 times! We are able to install PH correction units to bring the PH level back to neutral to enable safe usage of the water.

Possible stage four – removal of harmful chemicals (If present)

Sometimes the water you draw may contain harmful chemicals which cannot be removed with standard filters. In such cases other specialist filters can be used which will remove or reduce the harmful effects of many specific chemicals for example: Chlorine, lead, benzene, arsenic, mercury, cadmium, nitrates & pesticides.

Stage Five – Destroy pathogens present.

To destroy any pathogens that will be present through what are known as Ultra Violet filters. These filter types destroy all & any bacteria which may be present rendering your water clean & suitable for drinking. The wattage is specified based on your water test results.
It is far beyond the scope of this webpage to offer a definitive list of all known harmful or undesirable substances & the various means to remove them. Should your analysis show the presence of harmful substances we will advise you of your options & the filtration solutions available.
If you require a water test or would like advice please get in touch with us.
For filtration maintenance and servicing please get in touch with us for quotations, regular servicing or simple advice.